SLED16X5
The minileiste SLED16X5 skirting profile creates a discreet and innovative finish from the floor covering to the wall, window (frame) or stair tread – ideal for areas where connection and expansion joints are required by construction standards.
Suitable for bonded floor coverings such as parquet, tiles and levelled floors with a floor thickness from 5 mm and a connection joint between 6 and 13 mm.
Smart lighting geometry
The SLED16X5 skirting profile creates a discreet lighting ambience in the simplest way: a homogeneous light line visually separates the skirting profile from the wall when the LED lighting unit is switched on. Classic LED plastic cover profiles are not required and therefore do not impair the visual appearance even when switched off.
The SLED16X5 skirting profile of course can also be used without an LED unit.
Due to the inclined outer surface, almost no dust can settle on the profile.
All commercially available LED strips can be used for the LED lighting: When mounting the LED units horizontally, LED strips up to 8 mm wide can be used. LED strips up to 12 mm wide can be mounted on the sloping inner side of the profile.
The SLED16X5 skirting profile also can be used as a cable duct with or without LED unit.
LED strips are NOT included in the scope of delivery.
6 high-quality standard surfaces
SILVER
Silk matt EV1
TITANIUM
Silk matt C31
BLACK
Silk matt C35
WHITE
Fine structure RAL9016
GOLD
Silk matt EV3
ANTHRACITE
Fine structure RAL7016
Tool-free, quick and easy
Our SLED skirting profile can be installed easily, without tools and without visible fixing points: No drilling, no screws, no hammering, no mess, no noise, no hassle. Irregularities in the masonry can be easily levelled out by simply attaching additional mounting clips if required.
Simple installation in just 8 steps
Step 1
The width of the connection joint should be between 6 and 13 mm depending on the profile system used (see data sheets). The thickness of the floor covering must also be taken into account. Our X5 systems can be used from a minimum floor covering thickness of 5 mm.
Step 2
The dimensions for the profile cuts are taken from the wall surfaces. Miter cuts for inside and outside corners are taken into account.
Step 3
The profiles are cut to size. The miter cut for the inside or outside corner is made in one operation. The profile is pressed securely onto a wooden support and positioned in the saw so that it is cut. The cutting direction of the saw presses the profile against the wood support during the cutting process.
Step 4
The mounting clips are pushed into the end strip at the front. Attention: Two opposing shoulders are incorporated into the end strip, between which the mounting clips are easily guided.
Step 5
The mounting clips should be pushed into the end strip at a distance of about 30 to 60 cm from one another. Depending on the unevenness in the masonry, individual mounting clips can be installed at closer intervals so that the end strip is flush with the masonry.
Step 6
The end strip with the inserted mounting clips is now brought into the mounting position on the wall surface. With the mounting aid, the mounting clips are carefully spread apart by pressing the mounting clips towards the wall with the mounting aid.
Step 7
As soon as the clamping process is complete, the end strip is pressed down and the assembly aid removed. Now the tensioning and assembly process is repeated until all assembly clips of an end strip are tensioned and sunk. The end strip can be removed from the connection joint at any time for any corrections.
Step 8
The end strip is installed. After a short check, the next section can be installed.
Catalogs and data sheets in the download area
Here you will find all the important information for download: product catalog, data sheets, assembly instructions, etc.